Homepage

CVE-2026-89946 Affecting linux-6.12 package, versions <6.12.111-1~deb12u1

Severity

 Recommended
low

Based on default assessment until relevant scores are available.

Threat Intelligence

EPSS
0.21% (12th percentile)

Do your applications use this vulnerable package?

In a few clicks we can analyze your entire application and see what components are vulnerable in your application, and suggest you quick fixes.

Test your applications
  • Snyk IDSNYK-DEBIAN12-LINUX612-20506662
  • published5 Oct 2026
  • disclosed16 Sept 2026
Report a new vulnerability Found a mistake?

Introduced: 16 Sep 2026

NewCVE-2026-89946  (opens in a new tab)

How to fix?

Upgrade Debian:12 linux-6.12 to version 6.12.111-1~deb12u1 or higher.

NVD Description

Note: Versions mentioned in the description apply only to the upstream linux-6.12 package and not the linux-6.12 package as distributed by Debian. See How to fix? for Debian:12 relevant fixed versions and status.

In the Linux kernel, the following vulnerability has been resolved:

ASoC: cs35l33: drain threaded IRQ before runtime suspend

cs35l33_runtime_suspend() currently switches the codec into regcache_cache_only(true) and powers it down without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l33_irq_thread() can still run after suspend has closed off live register access.

A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1/2 after cache_only has been enabled, ignores the regmap_read() failures, and can still drive the AMP_SHORT_RLS, CAL_ERR_RLS, OTE_RLS, and OTW_RLS release paths.

Use disable_irq() before entering cache_only/power-off so any in-flight threaded handler is drained and no new IRQ thread can run during the suspended state. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only warns if devm_request_threaded_irq() fails, track whether the IRQ was actually installed before disabling or re-enabling it.